Richer red color and full joints for brick
Brick Paver Sealing in Hilliard, FL
Call (904) 980-0807 for a free brick paver sealing estimate in Hilliard.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Where in Hilliard is brick paver sealing available, and how soon is the reply?
Brick paver sealing is available across Hilliard, FL, and a local contractor answers within 1 business day, usually much sooner. The visit and the price are free, and you can turn the quote down if it does not suit you. To begin, call (904) 980-0807.
Brick pavers fade, collect mildew and lose sand like any other paver, and the red tones show every change in color and wear. A wet look sealer enriches the natural color and can restore a faded surface, says Premier Coatings, a Florida company. Sealing also locks in joint sand and gives weeds less room. To describe yours, send in the short form.
Do I have real brick or a brick-look concrete paver?
Check before you buy anything, because the product and the price depend on it. Many pavers sold as brick are molded concrete, while true clay pavers are fired. The paver industry association states that its care guide covers concrete pavers only, which is a hint that clay needs its own advice. A contractor can often tell on the first visit, and you can send in the short form to ask for that look.
Paver Sealing Hilliard Is Proud to Serve Northeast Florida
Why does brick cost more to seal than a plain concrete paver?
Brick takes more care at every step, so the same square footage costs more. A Northeast Florida price guide says brick and stone use a different sealer chemistry that costs 15 to 30 percent more than the standard range. A washing company adds that brick is cleaned at low pressure while concrete drives can take a surface cleaner. Call (904) 980-0807 to ask which one yours is.
| Brick area | Typical example | Standard rate $1.75 to $3.25 | Brick, 15 to 30 percent more |
|---|---|---|---|
| 250 sq ft | Front walk and stoop | $438 to $812 | $503 to $1,056 |
| 500 sq ft | Back patio | $875 to $1,625 | $1,006 to $2,113 |
| 800 sq ft | Drive with a courtyard apron | $1,400 to $2,600 | $1,610 to $3,380 |
The last column applies the guide's 15 to 30 percent increase to the standard range, the lowest figure on the low end and the highest on the high end. It is arithmetic, not a quote.
Should brick get a wet look finish or a matte one?
Wet look deepens the red and gives a sheen, and matte stays close to the day the pavers were laid. Premier Coatings offers both. Unilock warns that high gloss can be slippery when wet, so matte suits a shaded walk or a pool edge. Ask for a test square of each when you send in the short form.
What does a soft wash do for old brick?
Low pressure first
A washing company says brick gets a soft touch and careful low pressure so the surface stays intact. The paver industry association says steel brushes are not recommended.
Stain-specific cleaners
Rust, mildew and efflorescence each get their own cleaner, tried on a small spot first. The association says some acidic cleaners can slightly change paver color.
A fan nozzle at a distance
Unilock lists a 30 degree fan nozzle held about 12 inches off the surface, so the sand stays in the joints.
What are the white patches on my brick pavers?
Most often that is efflorescence, salts drawn out of the paver. The paver industry association says it can peak about 60 days after installation and last for months, and Unilock says it commonly clears in two to three months or up to a year. Sealing before it is gone can trap salt, so the contractor waits. Describe the patches when you send in the short form.
What happens in the brick sealing process, in order?
Brick jobs run in a fixed order, and the order protects the color. Each step waits for the one before it to dry. To ask how it would go at your house, call (904) 980-0807.
1. Test and measure
The contractor tries the cleaner on a small spot, measures the area and checks for loose or sunken bricks.
2. Gentle wash
Low pressure and a surface cleaner lift mildew and dirt without opening the joints.
3. Sand the joints
Dry sand fills each gap and is swept clear of the faces.
4. Flood coat and cure
Sealer goes on thin and even, as Premier Coatings describes, and the surface stays off limits until it cures.
How often does brick need another coat in Hilliard?
Expect about three to five years, the span Unilock and Family Handyman both give. A Northeast Florida washing company says two to three is typical and that sun and storms can push it toward two. A walk under shade usually outlasts a sunny drive. To check where your coat stands, call (904) 980-0807.
What does shade, moss and Hilliard rain do to brick?
Brick that stays damp turns green first, and Hilliard has plenty of damp. Nassau County rain peaks from May through September, with September the wettest at 6.91 inches on average. Pine cover keeps the ground below shaded and slow to dry, and Unilock says shaded pavers can need about 24 hours to dry after washing. That wait is built into the schedule. To plan around it, send in the short form.
How can I tell if an old coat on my brick has failed?
Look for a cloudy, white or flaking film, or water that soaks in without beading. A washing company says failed sealer is stripped first rather than coated over, and that sealing on wet or dirty pavers can leave a milky finish. Stripping costs $0.75 to $1.50 per square foot in a Northeast Florida price guide. To have a contractor check, send in the short form.
Empty joints make the job bigger. The same washing company says empty joints or failed sealer can turn the work into a two day restoration, since the brick has to dry between steps. Mention peeling or haze when you call (904) 980-0807.
Is sealed brick slippery on steps and walks?
Not if the finish is chosen with feet in mind. Premier Coatings says sealing can provide a slip resistant surface, while Unilock warns that high gloss may be slippery when wet. Steps, shaded walks and brick near a hose bib deserve the matte choice. Say where your brick sits when you send in the short form.
What does sealed brick look like around Hilliard?
Frequently Asked Questions
Is it good to seal pavers in Florida?
For brick pavers it can be, since sun, rain and humidity fade the red and invite mildew. A Florida paver company says sealing slows fading, locks in joint sand and cuts down weeds and organic growth. In return, the coat needs renewing every few years.
How to seal your brick pavers?
A contractor follows a set order. The bricks are washed with a gentle method, stains are treated, joints are refilled with sand, and sealer goes on only when everything is dry. Premier Coatings, a Florida company, finishes with a flood coat after the cleaning and re-sanding.
How much is paver sealing per square foot?
A Northeast Florida washing company lists $1.75 to $3.25 for cleaning, sanding and sealing. A price guide says brick and stone cost 15 to 30 percent more, so the same job can run about $2.01 to $4.23. Fewer square feet cost more per foot.
Is it better to spray or roll paver sealer?
Both tools work, and many crews use both. Unilock lists a sprayer with an adjustable nozzle and a foam or short pile roller. The tool matters less than a thin, even coat with no puddles.
Can sealer change the color of old red brick pavers?
A wet look sealer deepens the color, and a matte one stays closer to the natural look. A Florida paver company says wet look enriches natural paver color and can bring back faded ones. Ask for a test square in a corner first.
Do brick pavers need low pressure when they are washed?
Yes, they do. A washing company says brick gets a soft wash and careful low pressure, with the brick kept intact. High pressure can empty the joints, and Family Handyman says very soft pavers are better hand washed.
Are my pavers brick or concrete, and does it matter?
It matters for the price and the product. Many pavers that look like brick are concrete, and the paver industry association's care guide covers concrete pavers only. A contractor can tell by the edges and the color depth, and may pick a different sealer for clay.
Why do my Hilliard brick pavers look green in shade?
Shade holds damp, and algae and mildew grow in it. Nassau County gets about 49 inches of rain a year over about 109 days, and rain peaks in the summer months. Cleaning clears the film, and sealer afterward makes it rinse off faster later.
Ready to bring the red back?
Call or send the short form for a free look at your brick pavers, and a contractor replies within 1 business day, usually much sooner.
Free, no obligation